With time, brake pads on any vehicle have a tendency to put on out. Therefore, they ought to be altered once they normally wear out. In case your wish to alter the brake pads in your E46 BMW 3 Series, you are able to stick to the steps given below.
Step #1 Take away the tire
To begin with, you need to release the wheel nuts utilizing a spanner. Next, you need to lift the automobile in one affiliate with a effective vehicle jack to ensure that there’s no contact between your tire and also the ground. Afterward, you need to take away the nuts and separate the wheel in the hub.
Step #2 Take away the disc calipers
Make use of a screwdriver to get rid of the clip in the caliper. Then you need to connect to the sliding bolts by taking out the set of dust caps on the rear of the calipers. Now, you should utilize a 7mm Allen answer to take away the set of sliding bolts and separate it in the set up. That’s when you are able take away the caliper in the brake disc and connect to the brake pads.
Step #3 Switch the brake pads
Once you have removed the worn-out brake pads, you are able to take away the cap from the brake fluid bottle. Whenever you push the piston, the brake fluid will go back to the fluid reservoir. Now, you have to make space for that fresh brake pads.
Greasing the edges from the piston will help you to slide it effortlessly. Now, you need to apply grease towards the edges and rear from the brake pads to be able to slide them in with no problem. Slide the caliper to the disc by tapping it slightly utilizing a hammer. At this time, you need to be sure that the pads and calipers have been in the best place.
Now, you are able to grease the caliper sliding bolts to screw them within the thread and socket. Finally, you are able to switch the dust cover and employ a screwdriver to clip evidently from the caliper.
Step #4 Reattach the wheels
Now, use a wheel spanner to slip the wheel back to the hub from the wheel. Make certain that you simply stick to the star configuration. Next, lower the jack to create the vehicle back on the floor. Finally, be sure to tighten each nut one at a time.
Lastly, repeat exactly the same process around the second wheel.
Step #5 Look into the brake fluid level
After you have replaced both pads, you can examine the brake fluid to make sure it’s to the max level. If there’s an excessive amount of fluid, you need to use a syringe to attract the liquid.
The takeaway
In a nutshell, should you stick to the steps given above, it is simple to alter the brake pads by yourself.